Application - Brink Renovent HR Medium Consignes D'installation

Application

An appliance from the updated Brink Renovent HR series is a
constant-volume fans. The new generation stands out for its:
indication on the multiple switch;
• completely new frost protection system that ensures op-
timum performance of the appliance, even at very low at-
mospheric temperatures;
The appliance comes ready for use. All control equipment has
been mounted and checked in the factory.
On installation, the appliance must be connected to the air
ducts, the condensate discharge, the mains supply and the
multiple switch.
with the aid of the control panel on the appliance. See Chapter
4 for a detailed description 4.
The possibilities of the Renovent HR can be extended using
the separately available option pcb that the installer can place
in the appliance. For a description of the possibilities of the op-
tion pcb, see section 4.6 and wiring diagram section 9.4.
This option pcb is described in more detail in the installation
instructions that come with the option pcb.
It is possible to connect a Brink preheater to the basic pcb of
the Renovent HR without having to install an option pcb (see
section 9.4).
Renovent HR Medium/Large Renovent HR Medium/Large
Chapter 1
1 1