Putting Into Operation; Switching The Appliance On And Off 6; Setting The Air Quantity 6 - Brink Renovent HR Medium Consignes D'installation

Masquer les pouces Voir aussi pour Renovent HR Medium:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Putting into operation

6.1 Switching the appliance on and off
There are two methods to switch the appliance on or off.
1. Through software; the appliance remains connected to the
mains, when switching off bu software only the fans are
stopped.
2. Removing the mains plug or inserting it into the wall socket;
the voltage is taken from the appliance.
Switching on
• Mains power: connect the mains
plug to the electric installation
• Through
software;
simultane-
ously press keys "OK" and "+" to
switch on the appliance through
software
(Only possible after the appliance
has been switched off through
software.)
tes the position of the 3-way switch.
Switching off
• Through software; simultaneously
press keys "OK" and "-" to switch
on the appliance through software.
The text OFF appears on the dis-
play.
• Mains power: pull the mains plug
from the mains to take the voltage
from the appliance.
NOTE!
When working on the appliance, always take the voltage
and subsequently pulling the mains plug.
-
>3s
>3s
5383-0
Renovent HR Medium/Large
6.2 Setting the air quantity
The air quantity of the Renovent HR Medium/Large for settings
1, 2 and 2 have been adjusted in the factory at 100, /150/200
and 225/300 m
3
/h. The performance of the Renovent depends
stance.
Important:
Setting 1: must always be lower than setting 2.
Setting 2: must always be lower than setting 3;
Setting 3: adjustable between 50 and 300/400 m
If these conditions are not complied with, the air quantity of the
higher setting will automatically be adjusted.
here the air quantity for setting 3 will be changed from 300 to
3
280 m
/h):
1. Press key "F" during 3 seconds to
call up the settings menu.
2. Use key "+" to select the desired
parameter (U1 = setting 1: 1, U2 =
setting 2: 2, U3 = setting 3; U4, U5
and U8 only apply when a bypass
unit is used).
3. Press key "OK" during 1 second to
read the selected parameter value.
4. The keys "+" or "-" can be used to
modify the selected parameter va-
lue.
Chapter 6
-
3
/h;
>3s
17

Publicité

Table des Matières

Dépannage

loading

Ce manuel est également adapté pour:

Renovent hr large

Table des Matières