Version; Ducts Connection Options 2; Filter Door Position Options 2; Bypass 2 - Brink Renovent HR Medium Consignes D'installation

Chapter 2
The Renovent HR is available in two versions as regards ven-
tilation capacity:
• "Renovent Medium" has a ventilation capacity of up to 300
3
m /h at 150 Pa resistance in the duct system;
• "Renovent Large" produces a maximum of 400 m
Pa resistance in the duct system.
2.1 Ducts connection options
The Renovent HR is available in three versions as regards
ducts connections:
• all connections at the top; type 4/0
• "to dwelling" at the bottom; type 3/1
• "to dwelling" and "from dwelling" at the bottom; type 2/2
2.2 Filter door position options
The appliance is available ex factory in a right-hand or left-
hand version.
That changes the position of the duct connections.
on the left-hand side of the appliance.
2.3 Bypass
The appliance can be supplied ex factory with a nearly 100%
bypass, which can be used to interrupt the heat recovery, if
desired, to supplied fresh, cool outside air. The information
and diagram in these installation instructions refer to the 100%
bypass that is supplied ex factory; in this version the heat ex-
changer is equipped with a sliding grate that shuts off the air-
2
Both versions are available in various versions as regards
bypass unit.
The Renovent HR comes ready to plug in with a 230 V mains
plug and a connection for the low-voltage multiple switch on the
3 /h at 150 outside of the appliance.
For pictures and dimensions of these appliances, see sections
5.6.1 to 5.6.4.
It is possible to convert a right-hand appliance into a left-hand
sing the appliance, exchanging front and rear covers and mo-
ving the display.Similarly, a left-hand version can be converted
into a right-hand one.
supply air is shut off; in the left-hand version the discharge air
possible to mount a sliding grate.
The operation and preconditions of the bypass control are ex-
plained in more detail in section 4.3. The bypass unit that is
Renovent HR Medium/Large

Version

-