Connecting The Power Cord; Remote Control Battery Installation; Ntsc/Pal Settings - Yamaha DVD-S510 Mode D'emploi

16 PREPARATION

Connecting the power cord

After completing all connections, connect the AC power cord to an AC
power outlet
Note: When the player is in the "STANDBY" mode, it is still consuming some power.
If you wish to disconnect your player completely from the power, unplug the power
cord from the AC outlet.
Caution: Only qualified service personnel should remove the cover
or attempt to service this device.

Remote control battery installation

Loading the batteries
1
Open the battery compartment cover.
2
Insert batteries as indicated inside the battery compartment.
3
Close the cover.
Caution: Do not mix old and new batteries. Never mix
different types of batteries (standard, alkaline, etc.).

NTSC/PAL Settings

You can switch the NTSC/PAL setting of the DVD player to match the video
signal of your TV. This setting only affects the television's on-screen display
that shows the stop and setup modes. You may select either NTSC or PAL. To
change the DVD player setting to PAL or NTSC, follow the steps below.
1
Unplug the DVD player from the mains.
Press and hold 9 and ^/T on the front of the DVD player. While
2
holding 9 and ^/T plug in the mains.
3
After PAL or NTSC appears on the display panel of the DVD player,
release 9 and ^/T at the same time. The PAL or NTSC that appears
on the display panel indicates the current setting.
To change the setting, press ^/T within three seconds. The new
4
setting (PAL or NTSC) will appear on the display panel.