Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
SERVICE AND REPAIRS
•
Only service personnel trained by Hitachi, distributor or em-
•
ployer shall repair the Nailer.
Use only Hitachi parts supplied or recommended by Hitachi for
repair.
All quality Nailers will eventually require servicing or replacement
of parts because of wear from normal use.
In order to achieve the optimal performance of the NT50AGF Pneu-
matic Flooring Nailer, preventative Maintenance is recommended.
Manufacturer recommends replacement & re-greasing the Piston
O-Ring every 25,000 strokes (25,000 Nails). This will help prevent
premature wear and/or damage to the Piston & Cylinder and allow
the Nailer to be operated at the lower air pressure range.
Manufacturer recommends replacement & Lubrication of the O-
Rings in the Valve Body Assembly every 100,000 strokes (100,000
Nails). Again, this recommendation will help achieve longevity and
optimal performance of the NT50AGF Pneumatic Flooring Nailer.
NOTE:
Specifications are subject to change without any obligation
on the part of HITACHI.
Maintenance Chart
ACTION
Drain air line filter
daily
Clean filter element -
then blow air through
filter in direction oppo-
site to normal flow.
Clean magazine and
feeder mechanism.
Keep safety trigger
working properly.
Drain air compressor.
WARNING
WHY
Prevent accumulation
Open manual petcock.
of moisture and dirt.
Prevent clogging of
Follow manufacturer's
filter with dirt.
instructions.
Prevent a jam.
Blow clean daily.
Promote operator
Blow clean daily.
safety and efficient
Tool operation.
Keep the Nailer operat-
Open petcock on air
ing properly.
compressor tank.
— 29 —
English
HOW
Publicité
Table des Matières
