Ingeteam INGEREV CITY CW116 Manuel D'installation Et Usage page 25

Installing and connecting the unit
7. Connect the power cable and then switch ON (top position) the residual current device and
magnetothermic residual current device. See figure below.
Optionally the station can be fitted with a residual current device block with automatic reset. In this case the
residual current device must be activated (switch the switch ON; top position) and then slide the tab to the left as
shown in the following figure.
ABA2020IQM01_A - Installation and Operation Manual
Ingeteam
EN
ES
FR
IT
25