Equipment Transport; Transport; Unpacking - Ingeteam INGEREV CITY CW116 Manuel D'installation Et Usage

Ingeteam

5. Equipment transport

The unit must be protected, during transport, from mechanical knocks, vibrations, water splashes (rain) and any
other product or situation which may damage it or alter its behaviour. Failure to observe these instructions may
lead to loss of warranty on the product, for which Ingeteam is not responsible.

5.1. Transport

Transport using a pallet truck
At least the following requirements should be observed:
1. Deposit the charging stations packaged and centred relative to the forks.
2. Try to place them as close as possible to the part where the forks and the steering unit meet.
3. In all cases, observe the instructions in the pallet truck's user manual.
Transport using a forklift truck
At least the following requirements should be observed:
1. Deposit the charging stations packaged and centred relative to the forks.
2. Try to place them as close as possible to the part where the forks and the steering unit meet.
3. Ensure that the forks are perfectly level to avoid overturning the unit.
4. In any case, observe the instructions in the forklift truck's user manual.
Once the charging station has been transported to the place where it is to be located and only when it is to be
installed, unpack the station.
At this time, it can be transported vertically over a short distance without packaging.
Transport of the unpackaged unit
At least the following requirements should be observed:
1. Follow the necessary ergonomic advice for lifting weights.
2. Do not release the unit until it is perfectly secured or placed.
3. Ask someone else to guide the movements to be made.

5.2. Unpacking

Correct handling of the charging stations is vitally important in order to:
• Prevent damage to the packaging which enables them to be kept in optimum condition from shipping
until they are installed.
• Prevent the charging stations from receiving impacts and/or falling, which could deteriorate their
mechanical features.
• Avoid, as far as possible, vibrations which may cause subsequent malfunction.
If you observe any anomaly, please contact Ingeteam immediately.
Separating the packaging
You can deliver all the packaging to a non-hazardous waste management company.
In any event, each part of the packaging may be recycled as follows:
• Plastic (polystyrene, bag and bubble wrap): the appropriate container.
• Cardboard: the appropriate container.
16 ABA2020IQM01_A - Installation and Operation Manual
Equipment transport