Burning Wood - Dovre 2020 Installation Et Mode D'emploi

the chimney. You can avoid this problem by lighting
the fire as described below.
1. Stack two layers of medium sized logs crosswise.
2. Stack two to three layers of kindling crosswise on
top of the logs.
3. Place a firelighter between the bottom layer of kind-
ling and light the firelighter according to the instruc-
tions on the packaging.
4. Close the appliance door and open the primary
and secondary air inlets; see the following figure.
5. Allow the fire develop into a good blaze until there
is a glowing bed of charcoal. You can then add fuel
and adjust the appliance, see the chapter "Stoking
with wood".
Operating the air slides
The appliance has two air slides. The primary air slide
at the bottom of the door regulates the air under the
grid. The secondary air slide above the door regulates
the air for the glass (air wash system).
The air slide can be operated using the "cold hand".
The form of the "cold hand" depends on the model of
the appliance.
See the following figure for the open and closed pos-
itions of the air slide.
Subject to change because of technical improvements
09-20500-016
= Closed
l

Burning wood

After you have followed the instructions for lighting:
1. Slowly open the door of the appliance.
2. Spread the charcoal evenly across the bottom of
the stove base.
3. Stack a few logs on the charcoal.
09-20020-181
09-20020-180
= Open
o
17