Building Into An Existing Hearth - Dovre 2020 Installation Et Mode D'emploi

Changing the opening direction of
the door
If desired, the opening direction of the door can be
changed. The appliance is supplied with a door open-
ing to the right. Follow the instructions below.
1. Unscrew the door latch.
2. Unscrew the locking cam from the post.
3. Pull the hinge pins out of the hinges.
Be sure to support the door sufficiently; without
the hinge pins, the door can come loose unex-
pectedly.
4. Remove the door from the appliance.
5. Remove the washers from the hinge lobe and
place them on the other side of the appliance.
6. Position the door above the hinge lobes and insert
the hinge pins into the hinges.
7. Screw the latch onto the other side of the door.
8. Screw the locking cam onto the other side of the
door.
Comment: See the "Maintenance" chapter for adjust-
ing the closing of the door.
Connecting the fan to the mains
The fireplace insert is supplied with two built-in fans
and with a separate revolution control unit. The appli-
ance is also fitted with a thermo switch that turns the
fan on and off at a set temperature.
These parts must be connected to the mains as
shown in one of the connection diagrams below.
12
09-20020-182
See Appendix 2 for extended connection diagrams.
Building into an existing
hearth
To build the stove into an existing hearth, follow the
steps below:
1. Place the appliance at the right height and level it.
2. If you are going to put an external casing around
3. Close the base of the flue with incombustible
The connection diagram is specific to the
model.
Have the connection made by a qualified
installer.
The fireplace insert is provided with a three-
core cable.
The fireplace insert must be isolated from the
mains by a 2-pole switch.
Ensure that the fireplace insert is properly
earthed.
Keep the electrical cable of the appliance free.
the appliance, you should fit the clamping plates
supplied to the sides of the appliance without fully
tightening the screws. This is because the outside
casing fits between the appliance and the clamp-
ing plates; see next figure.
material.
Subject to change because of technical improvements