Hitachi YUTAKI S COMBI Serie Manuel D'utilisation page 32

UNIT INSTALLATION
6.1.3 Unpacking
All units are supplied with a wooden base, packed by a
cardboard box and plastic bag.
Firstly to unpack it, place the unit on the assembly area as close
as possible to its final installation location, to avoid damages in
transport. Two persons are required.
1 Cut the strapping bands and remove the adhesive tapes.
2 Remove the carton cap and then the plastic bag around the
unit. Afterwards, remove the rest of carton parts.
22 PMML0338B rev.1 - 03/2016
Strapping bands
Carton cap
Carton
parts
3 Unscrew the 4 screws which fix the unit to the wooden base.
Wooden
base
!
C A U T I O N
Be careful with the Installation and Operation manual and with the factory-
supplied accessories box located at the top of the unit.
4 Remove the indoor unit from the wooden base and place it
carefully on the floor, as near as possible to its final location.
kg
!
C A U T I O N
• Four people are required when lifting because of the heavy weight
of the unit.
• Be specially careful with the mounting foot once the unit is on the
floor. Avoid harsh handling of the unit, as it could cause damages to
the foot.
• Each mounting feet can be adjusted up to 30 mm, but keep all them
in the factory supplied position until the unit has been installed in its
final position.
Screws