Scheppach 5901308901 Traduction Des Instructions D'origine page 30

15. Troubleshooting
Problem Possible Cause
Fastening nut tightened insufficiently
Saw blade gets loose
after turning off the
motor
a) Fastening nut tightened insufficiently
Motor does not start
b) Extension cable defect
c) Connections on the motor or switch defect
Overload by dull saw blade, thermoprotection
No motor output turns
off automatically
is triggered
Burns on the cutting a) Fastening nut tightened insufficiently
b) Wrong saw blade
surface
c) with longitudinal cuts c) Longitudinal stop not parallel
d) with cross cuts
d) Slide carriage not parallel
30 І 168
 www.scheppach.com  service@scheppach.com  +(49)-08223-4002-99  +(49)-08223-4002-58
Help
Tighten fastening nut, M20 left-handed thread
a) Check the mains fuse.
b) See "Electrical Connection" in the operating
manual
c) Have it checked by an electrician
Insert a sharpened saw blade; motor can be turned
on again after the cooling period
a) Insert a sharpened saw blade
b) Insert saw blade with 20 or 28 teeth for
longitudinal cuts
c) Exchange the longitudinal stop
Align the slide carriage with the saw blade