Idle Speed Adjustment; Storing The Product; Transporting The Product - Toro 51998 Manuel De L'utilisateur

6. Tighten with a socket [torque to 177 in.lb. (20 Nm)
minimum, 221 in.lb. (24.97 Nm) maximum]. Do not
over-tighten.
NOTICE:
Be careful not to cross-thread the spark plug.
Cross-threading will seriously damage the
product.

Idle Speed Adjustment

See Figure 15.
WARNING:
The cutting head will move when adjusting the
idle speed. Wear all protective clothing and keep
all bystanders, children, and pets at least 50 ft.
(15 m) away. Make adjustments with the unit
supported by hand so that the cutting head does
not contact the ground or any object. Keep all
parts of your body away from the cutting head
and muffler. Failure to follow these instructions
could result in serious personal injury.
If the cutting attachment turns at idle, the idle speed screw
needs adjusting on the engine. Turn the idle speed screw
counterclockwise to reduce the idle RPM and stop the cut-
ting attachment movement. If the cutting attachment still
moves at idle speed, contact a service dealer for adjustment
and discontinue use until the repair is made.
WARNING:
The cutting attachment should never turn at idle.
Turn the idle speed screw counterclockwise
to reduce the idle RPM and stop the cutting
attachment, or contact a service dealer for
adjustment and discontinue use until the repair
is made. Serious personal injury could result
from the cutting attachment turning at idle.
Maintenance
Idle Speed
Screw

Storing the Product

Storing the product differs depending on the amount of time
it will be in storage.
Note: If the product includes another attachment, place the
storage cap on the end of the attachment shaft and hang it up
to store.
To Store the Product Short Term:
Follow these steps to store the product short term.
1. Clean all foreign material from the product.
2. Store the product in a well-ventilated place that is inac-
cessible to children.
To Store the Product Long Term:
If you do not intend to use the product for more than one
month, follow the storage procedures below.
Follow these steps to store the product long term.
1. Drain all of the fuel from the tank into a container ap-
proved for gasoline.
2. Run the engine until it stops.
3. Clean all foreign material from the product.
4. Store the product in a well-ventilated place that is inac-
cessible to children.
Note: Keep the product away from corrosive agents
such as garden chemicals and de-icing salts.
Note: Abide by all federal and local regulations for the
safe storage and handling of gasoline.

Transporting the Product

Follow these steps to transport the product.
1. Drain the fuel mixture into a container that is approved
for use with gasoline.
2. Carry the product by the front handle.
3. Secure the product in your vehicle or on a trailer.
Figure 15
19