Assembly; Unpacking; Packing List; Attaching The Front Handle - Toro 51998 Manuel De L'utilisateur

Assembly

Unpacking

This product requires assembly.
Carefully remove the product and any accessories from

the box. Make sure that all items listed in the packing
list are included.
WARNING:
Do not use this product if any parts on the pack-
ing list are already assembled to your product
when you unpack it. Parts on this list are not as-
sembled to the product by the manufacturer and
require customer installation. Use of a product
that may have been improperly assembled could
result in serious personal injury.
Inspect the product carefully to make sure no breakage

or damage occurred during shipping.
Do not discard the packing material until you have

carefully inspected and satisfactorily operated the
product.
If any parts are damaged or missing, please call

866-574-9242 (US) or 866-574-9243 (Canada) for as-
sistance.

Packing List

Straight Shaft Trimmer
Front Handle
Straight Shaft Grass Deflector
Lubricant
Operator's Manual
WARNING:
If any parts are damaged or missing do not
operate this product until the parts are replaced.
Use of this product with damaged or missing
parts could result in serious personal injury.
WARNING:
Do not attempt to modify this product or create
accessories not recommended for use with this
product. Any such alteration or modification is
misuse and could result in a hazardous condi-
tion leading to possible serious personal injury.
10
WARNING:
To prevent accidental starting that could cause
serious personal injury, always disconnect the
engine spark plug wire from the spark plug
when assembling parts.

Attaching the Front Handle

See Figure 2.
Follow these steps to attach the front handle.
1. Press the front handle onto the top of the upper shaft, in
the position indicated by the arrow on the shaft, angling
the handle toward the throttle trigger.
2. Place the front handle along the upper shaft to a posi-
tion that allows for comfortable operation.
3. Insert the handle support tab into the slot in the front
handle.
4. Align the hole in the front handle with the hole in the
handle support.
5. Insert bolt through holes in front handle and handle
support. Secure handle in place using wing nut.
Note: Do not cover any portion of the warning label with
the front handle.
Bolt
Slot
Tab
Front
Handle
Throttle
Trigger
Handle
Support
Wing
Nut
Figure 2
Assembly