Idle Speed Adjustment; Storing The Product; Transporting The Product; Installing Reel Easy String Head - Toro 51954 Manuel De L'utilisateur

IDLE SPEED ADjUSTMENT

See Figure 19.
If the cutting attachment turns at idle, the idle speed screw
needs adjusting on the engine. Turn the idle speed screw
counterclockwise to reduce the idle RPM and stop the cut-
ting attachment movement. If the cutting attachment still
moves at idle speed, contact a service dealer for adjustment
and discontinue use until the repair is made.
WARNING:
The cutting attachment should never turn at idle.
Turn the idle speed screw counterclockwise
to reduce the idle RPM and stop the cutting
attachment, or contact a service dealer for
adjustment and discontinue use until the repair
is made. Serious personal injury may result
from the cutting attachment turning at idle.

Storing the Product

Storing the product differs depending on the amount of time
it will be in storage.
Note: If the product includes another attachment, place the
storage cap on the end of the attachment shaft and hang it up
to store.
To Store the Product Short Term:
Follow these steps to store the product short term.
1. Clean all foreign material from the product.
2. Store the product in a well-ventilated place that is inac-
cessible to children.
To Store the Product Long Term:
If you do not intend to use the product for more than one
month, follow the storage procedures below.
Follow these steps to store the product long term.
1. Drain all of the fuel from the tank into a container ap-
proved for gasoline.
2. Run the engine until it stops.
3. Clean all foreign material from the product.
4. Store the product in a well-ventilated place that is inac-
cessible to children.
Note: Keep the product away from corrosive agents
such as garden chemicals and de-icing salts.
Note: Abide by all federal and local regulations for the
safe storage and handling of gasoline.

Transporting the Product

Follow these steps to transport the product.
1. Drain the fuel mixture into a container that is approved
for use with gasoline.
2. Carry the product by the front handle.
3. Secure the product in your vehicle or on a trailer.
Maintenance
Idle Speed
Screw
Straight Shaft
Curved Shaft

Installing Reel Easy String Head

See Figures 20 - 21.
 Stop the engine and disconnect the spark plug wire.
 Open the Reel Easy string head by depressing the
latches on each side. The contents of the string head are
spring loaded, so keep your other hand over the string
head cover while depressing the latches.
 Remove the string head cover, knob, and spool and set
aside.
 Place the upper housing on the drive shaft. Make sure
the string head is fully seated.
 Install the hex bolt into the opening on the drive shaft
and secure using the hex-shaped opening in the knob to
tighten. Turn clockwise for curved shaft and counter-
clockwise for straight shaft to tighten.
Figure 19
Cover
Latches
Knob
Spool
Spring
Hex Bolt
Spring Head
Latch
Opening
Figure 20
21