Description; Operation - Dustcontrol DC 2800c Manuel D'instruction

Description

The machine should be used for suction and separa-
tion of dried not inflammable dust. The machine fulfil
the demands for separation of unhealthy dust.
The DC 2800c is, despite it's compact size, a full
capacity Dustcontrol machine. It is stable, tough and
reliable and particularly suited to spot extraction in
many different applications ie: welding, grinding, san-
ding and cleanup with the 38 mm program.

Operation

Connect the unit to a suitable power
source, note requirements on the ID
plate. If an extension cord is to be used,
only waterproof cords are acceptable.
The filter is genereally cleaned once or
twice daily during normal continuous
operation. The unit must be in opera-
tion to perform filter cleaning. Loose the
tube from the suction pipe and press the
plastic cage against the black stop head
on the exhaust channel so that maxi-
mum pressure is created in the cyclone.
Open the port on the side o the unit three
to six times. This reverse pulse of air
cleans the filter.
The plastic sack should be changed only
after filter cleaning is done and when
the collected material level is about 5
cm under the foot valve.
The collection sack must be tied off when it is removed from the unit. This is most easily done with the
sacks own tie strap. Be sure to put on a new strap before installing a new collection sack. Follow the
instructions below.
Use only original Dustcontrol spare parts.
Dust separation is in any case as efficient as with the
larger Dustcontrol machines.
The design is ergonomic and appealing. With a very
low sound level of 70 dB(A) at 1m distance, the
DC 2800c is suitable for use in areas which are sen-
sitive to noise. The direct drive two stage high pressure
fan is integrated into the units top. The 1200W capa-
city fan is double insulated for higher safety.
DC 2800c, 10
Art nr 9453