Technical Data - IKRA BF 25 Mode D'emploi

Petrol brush cutter BF 25

TECHNICAL DATA

Motor power
Motor type
Displacement
Fuel
Tank capacity
Idle speed
Max. motor speed
Max. speed scythe
Max. speed trimmer
Cutting width
Trimming line thickness
Trimming line spool capacity
Trimming line feed
Weight (empty tank)
Noise pressure level
Operational vibration
Idle vibration
Technical changes are reserved.
The petrol brush cutters are constructed in accordance with EN ISO 11806:2008 regulations and comply fully with
the product safety regulations.
Notice: The vibration value indicated was determined with a standardized tool and can be used to make comparisons
with other petrol equipment as well as temporary estimates of the load through the vibrations.
WARNING! The vibration value may vary according to the usage of the machine and its fitted equipment, and be
higher than the one indicated. Safety measures must be established to protect the user and must be based on the load
estimate generated by the vibrations in real usage conditions. In this regard, all the operational cycle phases must be
taken into consideration, such as switching off or idle running.
Warning: Prolonged exposure to vibrations can cause injuries and neurovascular disorders (also called "Renaud's
syndrome"or "white hand"), especially to people suffering from circulation disorders. The symptoms can regard the
hands, wrists and fingers and are shown through loss of sensitivity, torpor, itching, pain and discolouring of or structural
changes to the skin. These effects can be worsened by low ambient temperatures and/or by gripping the handgrips
excessively tightly. If the symptoms occur, the length of time the machine is used must be reduced and a doctor con-
sulted.
WARNING: This machine's starter unit generates an average sized electromagnetic field, but it is not however possi-
ble to exclude the possibility of interference on any active or passive medical devices that operators may be wearing;
this could be risky for their health conditions. All those using medical devices should always consult their GP, or the
device manufacturer, before using this machine.
When working with the device, a certain level of noise cannot be avoided. Noisy work should be scheduled for hours,
during which it is allowed by statute or other local regulations. Adhere to any applicable rest times and limit your work-
ing time to the necessary minimum time. For your personal protection and the protection of people nearby, suitable
hearing protection must be worn.
Noise emission information in accordance with the German Product Safety Act (ProdSG) and the EC Machine
Directive: the noise pressure level at the place of work can exceed 80 dB(A). In such cases the operator will require
noise protection (e.g. wearing of ear protectors).
Please do also consider any local regulations concerning noise protection!
kW
cm³
Petrol/oil mix
ml
rpm
rpm
rpm
rpm
cm
mm
m
kg
dB (A)
m/s²
m/s²
GB-2
0,75
2-stroke, air-cooled, motor with chrome cylinder
25
40:1
450
3000
10500
9500
8500
43 (blade = 23)
2,5
4,0
Automatic (by tapping)
6,2
[K 3,0 dB(A)]
98,2
2
9,14 [K 1,5 m/s ]
2
4,01 [K 1,5 m/s ]