Possible Malfunctions; Technical Data - IKRA IBHS 62 Manuel D'utilisation

Possible malfunctions

Malfunction
Hedge trimmer does not run
Hedge trimmer cuts with
interruptions
Motor runs, but cutter remains
stationar
Cutter is hot

Technical data

Petrol-Driven Hedge Trimmer IBHS 62
Max. motor power at speed
Capacity
....................................................................................................
Idling speed
..............................................................................................
Ignition system
.........................................................................................
Spark plug
................................................................................................
Fuel tank capacity
...................................................................................
Mixing ratio (petrol/two-stroke oil)
Cutting length
...........................................................................................
Cutting
.......................................................................................................
Weight (tank empty, blade guard removed)
Sound pressure L
pA (acc. to EN ISO 10517)........................................
Sound power level L
WA (acc. to Directive 2000/14/EC)........................
Vibration
(acc. to EN ISO 10517)..............................................................
Technical changes are reserved.
GB | Operating instructions
Possible cause
• No fuel
• Fault in the fuel line
• Petrol filter blocked
• Spark plug defective
• Carburettor defective
• Internal fault
• Internal fault
• On/off switch defective
• Cutter jammed
• Internal fault
• Clutch defective
• Insufficient lubrication -- > Friction
• Insufficient sliding clearance
• Cutter is blunt
..................................................................
.......................................................
...................................
Remedy
• Check the amount of fuel
• Check the fuel line for kinks or
damage
• Clean or replace the petrol filter
• Replace the spark plug
• Contact the manufacturer or a recom-
mended customer service centre
• Contact the manufacturer or a recom-
mended customer service centre
• Contact the manufacturer or a recom-
mended customer service centre
• Contact the manufacturer or a recom-
mended customer service centre
• Remove object
• Contact the manufacturer or a recom-
mended customer service centre
• Contact the manufacturer or a recom-
mended customer service centre
• Oil the cutter
• Adjust the sliding clearance
• Have the cutter sharpened
0,9 kW at 8500 rpm
3
25,4 cm
3400 rpm
Electronic ignition
NHSP L8RTF
0,6 l
40:1
600 mm
up to 27 mm
6,1 kg
91 dB(A)
K = 3 dB
114 dB(A)
K = 3 dB
2
7,5 m/s
K =1,5 m/s
13
2