Concealing The Integral Seat Belts; Installation Of The Booster Seat With Backrest Without Isofix Anchors; Installation Of The Booster Seat With Backrest With Isofix Anchors - JANE CONCORD GROOWY iSIZE Mode D'emploi

IMPORTANT: To ensure that you do not use the integral seat
!
belt for any longer than necessary, GROOWY has a safety me-
chanism that prevents the headrest from being moved higher
than a certain point if the integral seat belts have not been
concealed first
K_CONCEALING THE INTEGRAL SEAT BELTS
• The headrest (3) should be set to its highest position.
• Take the pads off the shoulder belts and keep them safe.
• Take the upholstery off the seat from the flap that goes over the backrest
until the buckle compartment is uncovered.
• Pass the buckle through the buttonhole in the upholstery, and put it in the
3
compartment. .h
• Slide the shoulder straps behind the flap over the headrest. NOTE: To pre-
vent the incorrect use of the safety seat, it will not be possible to
move the headrest up any higher until this step has been completed.
First remove the padding from the shoulders.
• Pass both straps behind the flap of the headrest.
• The upper parts of the buckle can be concealed in the gaps in the interior
sides of the seat. 3 .j
30
EN
3
.f
3
.f
3
.g
3
.i
L_INSTALLATION OF THE BOOSTER SEAT
WITH BACKREST WITHOUT ISOFIX
ANCHORS
• If you decide to install the GROOWY booster seat with backrest without the
ISOFIX anchors, you should just place it on the vehicle seat and pass the
seat belt through the belt guides under the armrest and on one side of the
headrest. These steps will be indicated with a green signal.
M_INSTALLATION OF THE BOOSTER SEAT
WITH BACKREST WITH ISOFIX ANCHORS
The booster seat with backrest can be installed with the ISOFIX
anchors, this gives the seat more lateral stability.
To install it follow the steps below:
• The ISOFIX anchors (6) are automatically extracted by firmly pulling both the
red rings (9) found on the front of the base.
• In some vehicles, the ISOFIX anchors are difficult to access or they are hidden
between the foam sections of the vehicle seat. With the seat we have provided
some guides (19) making it easier to locate them, insert them before the fol-
lowing step.
• Guide the anchors towards the axles in your vehicle and press until both sides
are locked into place. Two green signals on the front of the base (8) will show
that they are securely anchored. If one or both of the signals are red, try again.
3 .e
• Lastly, press the base (1) against the backrest of the vehicle.
3
.l
3
.e