Use For Children From 100 To 150 Cm; Turning The Safety Seat Into A Booster Seat With Backrest; Concealing The Integral Seat Belts; Installation Of The Booster Seat With Backrest Without Isofix Anchors - JANE GROOWY Mode D'emploi

USE FOR CHILDREN FROM 100 TO 150 CM WITH
VEHICLE SEAT BELT
J. TURNING THE SAFETY SEAT INTO A BOOS-
TER SEAT WITH BACKREST
• To turn the GROOWY safety seat into a booster seat with bac-
krest you need to rotate the seat 180 degrees on the base. To
do this step you need to uninstall the seat.
• Pull the straps (7) to release the ISOFIX anchor. (9)
• On the bottom of the base there is a red lever that unlocks
the seat rotation system. Press it and turn the seat to the next
3
locking position. .b
• Adjust the length of the leg to the shortest position, to do this
release the locking system of the leg by sliding the button (9a)
3
to the right. .c
• Insert the leg into the slot in the base. There is a lock to hold it
3
in place. .d
IMPORTANT: To ensure that you do not use the in-
!
tegral seat belt for any longer than necessary,
GROOWY has a safety mechanism that prevents the
headrest from being moved higher than a certain
point if the integral seat belts have not been con-
cealed first
30
EN
IM 2111,01 GROOWY4 acordeo145x90 ES_EN_FR_DE_IT_PT.indd 30
K. CONCEALING THE INTEGRAL SEAT BELTS
• The headrest (3) should be set to its highest position. .
• Take the pads off the shoulder belts and keep them safe.
• Take the upholstery off the seat from the flap that goes over
the backrest until the buckle compartment is uncovered.
• Pass the buckle through the buttonhole in the upholstery, and
put it in the compartment.
• Slide the shoulder straps behind the flap over the headrest.
3
.a
NOTE: To prevent the incorrect use of the safety seat, it will
not be possible to move the headrest up any higher until this
step has been completed. First remove the padding from the
shoulders.
• Pass both straps behind the flap of the headrest.
• The upper parts of the buckle can be concealed in the gaps in
the interior sides of the seat.
L. INSTALLATION OF THE BOOSTER SEAT WITH
BACKREST WITHOUT ISOFIX ANCHORS
• If you decide to install the GROOWY booster seat with bac-
krest without the ISOFIX anchors, you should just place it on
the vehicle seat and pass the seat belt through the belt gui-
des under the armrest and on one side of the headrest. These
steps will be indicated with a green signal.
3
.f
3
.f
3
.g
3
.h
3
.i
3
.j
3
.l
18/2/20 11:06