Safety Notes - Monacor TVCCD-2006 Mode D'emploi

GB Please unfold page 3. Then you can always see
the operating elements and connections de-
scribed.
1 Connections
1.1 Camera rear panel (fig. 1)
1 Power supply connection 12 V ,
centre pin = positive pole
necessary plug 5.5/2.1 mm (outside/inside dia-
meters)
2 Input for external synchronization, 0.5 Vpp
3 Video output, 1 Vpp at 75 Ω
4 Jack for video-controlled lens, pin connection for
the included plug see fig. 2
1.2 Pin connection of the plug for video-con-
trolled lenses (fig. 2)
1 Output supply voltage 12 V
2 Ground
3 not connected
4 Video output, 1 Vpp

2 Safety Notes

•
This appliance corresponds to the directive for
electromagnetic compatibility 89/336/EEC.
•
Protect the camera against impurities, humidity,
and heat (permissible operating temperature
range 0-40°C).
•
The CCD image sensor chip must be protected
against dust or other impurities and must not be
touched with the fingers in any case.
•
For the cleaning only use a dry cloth, by no means
chemicals or water.
10