Connecting/Disconnecting 5/8" And 3/4" Drum Machine Cable Couplings - RIDGID K-6200 Mode D'emploi

K-6200 Drain Cleaning Machine
Connecting/Disconnecting 5/8" and 3/4" Drum Machine
Cable Couplings
Keep couplings clean and lubricated. Plunger pin must move freely and fully extend to secure connection.
New style – Plunger pin
Screwdriver required.
Connecting
1
1 . Slide the couplings together. If needed, depress plunger
pin.
2 . Confirm connection is secure. (plunger pin fully ex-
tended).
Disconnecting
1
2
1 . Insert the screwdriver to depress the plunger pin.
2 . Push the couplings apart until the male coupling con-
tacts the screwdriver.
3 . Remove the screwdriver and push the couplings apart.
Figure 3
Instructions For Installing Loading Wheel
(Optional Accessory)
1. Locate the two pre-drilled holes near the top of the
handle.
2. Bolt loading wheel to handle using the
bolts and lock nuts as shown in Figure 4.
NOTE! Loading wheel swivels up and down. Raise wheel
for loading, lower wheel while transporting or
operating machine.
2
3a 3b
5 / " carriage
16
Old style – Rotating pin
Screwdriver required.
Connecting
Hash Mark
1 . Slide the couplings together.
2 . Rotate pin so hash mark is away from end of cable (to-
wards "L" stamped on coupling). Confirm connection is
secure.
Disconnecting
1 . Rotate pin so hash mark is towards end of cable (away
from "L" stamped on coupling).
2 . Push the couplings apart.
Figure 4 – Loading Wheel