Control Panel (Sj-Xg640M, Sj-Xg690M, Sj-Xg740M); Door Alarm - Sharp SJ-XG640M Mode D'emploi

Control panel
Controlling temperature icons
Button Meaning
Controlling temperature
of Freezer compartment
Controlling temperature of
Refrigerator compartment
Note
• All mode are off initially. When you press one of the
keys, control panel is active after the beep sound.
• When you press one of the keys, mode indicator in
operation lights up. When Express cool is in operation,
the indicator flashes.
• If you want to light up the temperature indicator, press
"F" or "R" button while the control panel is active.
Operations of useful modes
Extra cool Press the mode button.
Express (Beep)
freezing
Vacation mode
Express cool Press the mode button for
3 seconds or more.
(Beep, beep, beep)

Door Alarm

• When the refrigerator door is left open for over 1 minute, door alarm sounds once, and again after 1 minute.
• If the door is left open for approx. 3 minutes, the alarm sounds continuously.
• The alarm stops after closing the door.
If the door alarm does not stop
If the door alarm does not stop after closing all doors, it is a defect.
Contact the SHARP service center for service.
Method of stopping the door alarm temporarily
• Press "F" button and "R" button simultaneously and continuously for 3
seconds or more. (Beep, beep, beep)
• The door alarm sounds again after approximately 2 days.
(SJ-XG640M, SJ-XG690M, SJ-XG740M)
Default setting
Start operation
Lighting
Flashing
Useful modes icons
Button Meaning
Extra cool
Express freezing
Express cool
Vacation mode
Plasmacluster
*The Plasmacluster operates automatically when the
refrigerator is powered on.
There is no need to switch on/off.
• When there is no operation for approximately 1 minute,
the display turns off automatically.
• If the refrigerator stops because of power failure, the
modes except for Extra cool, Express freezing and
Express cool function the same way as before at the
time of re-power.
Cancel operation
Press the mode button.
(Beep)
Press the mode button.
(Beep)
EN
Default setting
OFF
ON*
Turn off
Turn off
EN-8