ResMed S9 AutoSet Mode D'emploi page 9

Air tubing technical specifications
ClimateLine heated air tubing
MAX
ClimateLine heated air tubing
SlimLine air tubing
Standard air tubing
Heated tubing temperature cut-out
Notes:
• The manufacturer reserves the right to change these specifications without notice.
•
The temperature and relative humidity settings displayed for ClimateLine or ClimateLine
measured values.
•
Check with your clinician/service provider before using the SlimLine air tubing with devices other
than the S9 or H5i.
Humidifier performance
The following settings have been tested at 22°C ambient temperature:
CPAP mask
pressure, cm H O
2
4
10
20
a. AH - Absolute Humidity in mg/L.
b. BTPS - Body Temperature Pressure Saturated.
Symbols
The following symbols may appear on your S9, H5i, power supply unit, air tubing or packaging.
Caution; Read instructions before use;
Not drip proof;
Manufacturer;
Flexible plastic and electrical components,
6'6" (2 m), 15 mm inner diameter
Flexible plastic and electrical components,
6'3" (1.9 m), 19 mm inner diameter
Flexible plastic, 6' (1.8 m), 15 mm inner diameter
Flexible plastic, 6'6" (2 m), 19 mm inner diameter
 106°F ( 41°C)
RH output %
Setting 3 Setting 6
90
95
95
Type BF equipment;
European Authorised Representative;
Nominal system output AH
Setting 3
100
100 11.5
100
Follow instructions for use;
Class II equipment;
MAX
Setting 6
10 18
21
11 18
Drip proof;
Start/Stop;
European RoHS;
are not
a b
, BTPS
9