ResMed S9 AutoSet Mode D'emploi page 14

•
Do not overfill the water tub as water may enter the device and air tubing.
•
Take care when handling your H5i as the water/water tub may be hot. Allow 10 minutes for the
heater plate and any excess water to cool.
•
The H5i docking station should only be connected or disconnected when the water tub is empty.
•
Make sure that the water tub is empty before transporting the H5i.
•
Do not operate the H5i on an aircraft as water may enter the CPAP device and air tubing during
turbulence.
•
Always place the H5i on a level surface below the level of the user to prevent the mask and tubing
from filling with water.
•
The H5i should be used with caution for users who are unable to remove the mask for themselves.
• If liquids are inadvertently spilled into or on the H5i docking station, unplug the device from the
power outlet. Disconnect the docking station from the CPAP device and allow the docking station to
drain and dry before re-using.
AIR TUBING WARNINGS
•
If damage to the air tubing results in air leaking, stop using the air tubing.
•
Do not wash the air tubing in a washing machine or dishwasher.
•
The ClimateLine or ClimateLine
14
MAX
is designed only for use with the H5i.