Atag Teppan Yaki TY3011M Notice D'utilisation page 125

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

INSTALLATION INSTRUCTIONS
Order in which to build in the appliance
1. Turn the appliance upside down and place it on the
worktop. Remove the protective foil from the sealing tape
and apply the tape around the cut-out in the worktop. Start
at the rear side of the appliance and tape the sealing strip
along the corners. Make sure that the ends of the sealing
strip fi t tightly together.
2. Measure the thickness of the worktop. Set the control box
to this thickness by correctly positioning the three screws
on the bottom of the control box. The sizes indicated
correspond to the thickness of the worktop.
10 mm
16 mm
20 mm
32 mm
40 mm
EN 29
Top-stone
10 mm
10 mm
16 mm
16 mm
20 mm
20 mm
32 mm
32 mm
40 mm
40 mm
contents

Publicité

Table des Matières
loading

Table des Matières