Technical Data - WAGNER WOOD & METAL SPRAYER W 300 Mode D'emploi

GB
Problem
Device does not
function
Paint in the
ventilating hose

23. Technical Data

Max. viscosity:
Power source:
Power consumption:
Atomizing output:
Max. flow rate:
Double insulation:
Sound pressure level*:
Sound pressure output*:
Oscillation level*:
Air hose length:
Weight:
* Measured in accordance with EN 60745-1
Information about the oscillation level
The specified oscillation level has been measured according to a standard test
procedure and can be used to compare against electric tools.
The oscillation level is also for determining an initial assessment of the vibrational strain.
Attention! The vibration emission value can differ from the specified value when the
electric tool is actually in use, depending on how the electric tool is being used. It is
necessary to specify safety measures to protect the operating personnel. These measures
are based on an estimated shutdown during the actual conditions of use (all parts of the
operating cycle are taken into consideration here, for example periods when the electric
tool is switched off, and, when it is switched on but running without any load).
28
Cause
•
Device overheated
•
Diaphragm soiled
•
Diaphragm defective
Technical Data
130 DIN-s
230 V , 50 Hz
~
350 W
105 W
125 ml/min
80 dB (A); Uncertainty K = 4 dB
93 dB (A); Uncertainty K =4 dB
< 2.5 m/s²; Uncertainty K = 1.5 m/s²
1,8 m
approx. 2.8 kg
Remedy
➞ Unplug the power plug,
let the device cool down
approx. 30 minutes, do not
bend the hose, check the
air filter, do not cover the
intake slots
➞ Clean the diaphragm
➞ Replace the diaphragm
W 300