Internal Terminal Block; User Menu; Pause The Pump; Priming The Pump - aqua HC 997 Serie Manuel De Programmation

HC997-999 – MOD. A
Digital multifunction solenoid metering pump
2.5 I
NTERNAL TERMINAL BLOCK

CAUTION: Always disconnect power when servicing the unit.
INPUT
INPUT mA
INPUT FLOW
INPUT PULSE
INPUT LEVEL

3.0 USER MENU

Once the pumps is switched on the display show an user menu and is possible to read some information regarding
the functioning mode and the possibility to pause and prime the pump.
Moreover from the standby menu is possible to enter in the user menu to perform some functions.
3.1 P
AUSE THE PUMP
From the standby menu press the
Press twice the key to go back at the standby menu.
3.2 P
RIMING THE PUMP
From the standby menu press twice the
Keep pressed the
Press the key to go back at the standby menu

After 10 seconds the pump automatically goes back to the standby menu if no key is pressed.
ADSP9000026
PINS DESCRIPTION
Input to connect a 0÷20mA current
1-2
signal that comes from a controller.
Input to connect a flow sensor type
3-4-5
PNP.
6-7 Input to connect a water meter.
8-9 Input to connect a level probe.
key, the display will show:
key, the display will show:
key to activate the pump.
18/09/2015 Rev.1.5
TECHNICAL FEATURES
ENGLISH
WHAT CONNECT
25/100