Backlight; Cleaning And Care; Troubleshooting - auna Connect 120 Mode D'emploi

EN
42
Info
View the firmware version and the radio ID.
Privacy policy
View the information of Privacy Policy.

Backlight

You may change the backlight of each environment (power on level or
standby) to High, Medium, Low or Auto. And adjust the timeout duration
which the radio turns to standby backlight level when it has not been
controlled.

CLEANING AND CARE

• Always unplug the device from the mains before cleaning it.
• Never use aggressive cleaning agents or scouring pads for cleaning, as
this could damage the surface of the device.
• Wipe the device with a soft and dry cloth. If the device is very dirty, the
dirt can be removed with a slightly damp cloth. After cleaning, make
sure to dry the device with a damp cloth before using it again.
• Keep the packaging of the device in order to store it if necessary.

TROUBLESHOOTING

Error
The device does not switch
on.
No sound.
No network connection can
be established.
Remedy
Check it the power adaptor is connected
properly.
1. Turn on the sound as it may be muted
2. Increase the volume.
3. Pull any connected headphone or
speaker from the connector jack.
1. Check the WLAN function.
2. Try to set an IP address at the device.
3. Activate the DHCP function on the
router and make the connection again
at the device.
4. A firewall is activated on the network
– set the respective program in such a
way that access is possible.
5. Reboot the router.