Dab+ Radio; Fm Radio - auna Connect 120 Mode D'emploi

DAB+ RADIO

DAB mode receives DAB/DAB+ digital radio and displays information about
the station, stream and track playing.
Scanning for stations
The first time you select DAB radio mode, or if the station list is empty, the
radio automatically performs a full scan to see what stations are available.
You may also need to start a scan manually to update the list of stations.
• To start a scan manually, choose Full scan.
• To scan only stations with good signal strength, select Local scan. Once
the scan is complete, the radio shows a list of available stations.
• To remove stations that are listed but not unavailable, choose Prune
invalid.
• Turn the navigate reel to view a list of stations and press to select.
Once selected, the station plays and the screen show information about
station, track or show as broadcast.
Settings
• Dynamic range compression (DRC): If you are listening to music with a
high dynamic range in a noisy environment, you may wish to compress
the audio dynamic range. This makes quiet sounds louder, and loud
sounds quieter. You can change DRC as off, low or high.
• Station order: You can choose the order of the DAB station list to be
either Alphanumeric, Ensemble or Valid. Ensemble lists groups of
stations that are broadcast together on the same ensemble. Valid lists
valid stations first, alphanumerically, then off-air stations.

FM RADIO

FM radio mode receives analogue radio from the FM band and displays RDS
(Radio Data System) information about the station and where broadcast.
To find a station, press OK (SCAN). The frequency display starts to run up
as the device scans the FM band. Alternatively, you can scan up or down by
pressing and holding the buttons / or tune manually with quick presses,
or by turning the reel.
Settings
• Scan settings : By default, FM scans stop at any available station. This
may result in a poor signal-to-noise ratio (hiss) from weak stations.
To change the scan settings to stop only at stations with good signal
strength, select "Yes" after choosing "Strong station only?".
EN
37