Setting Network - auna Connect 120 Mode D'emploi

First-time setup
• When powering the device on for the first time, it displays information
of privacy policy. Press OK (SCAN) to continue.
• Then a setup wizard appears for helping you setup the main use of the
device. Select "YES" and confirm your selection and launch the setup
wizard.
• If you select "NO", the next window will ask you choose if you want to
start the setup wizard again next time you power the device on.
Setup wizard helps you setup the main use of the device:
Selecting the menu language
Rotate the knob to select the menu language you want from the list and
press OK (SCAN) to confirm.
Setting date and time
Select "12" for 12-hour display format or "24" for 24-hour display format.
If you select the 12-hour format, the display shows "AM" in the morning or
"PM" in the afternoon after the time.
After this, the following options are available, to define if the time to be
synchronized from radios: "Update from DAB", "Update from FM", "Update
from Network" or "No update".
• If you choose "Update from Network" you must indicate your time zone
in the next window.
• Next choose "ON" for summer time, otherwise select "OFF".
• If you choose "No update", you will have to enter the date and time
manually.
• "AM"/ "PM" displays only if you have chosen the 12-hour time format.
Select "AM" for the morning hours or "PM" for the afternoon hours.

Setting network

Firstly the device asks if keep network connected. If you want to control the
device in all operating modes via the app, select "YES". If choosing "NO", it
is not possible to control the device from the app in the (Standby, AUX IN,
FM, DAB) operating modes. Note that the power consumption in standby
mode will be higher when the network connection is kept up.
• Any WLAN networks found are listed on the display, along with their
names.
• After selecting the network, you will be asked for input a standard
encryption.
EN
35