Sentiotec Pro D Serie Instructions D'installation Et D'utilisation page 133

Instructions for use for the user
Perform the following steps to save the settings in the table above in user
program 2:
1. Select the temperature symbol 5 by pressing the mode button D.
Then briefly press the On/Off button A.
► The sauna heater switches on.
2. Set the temperature to 45 °C with the plus button B and the minus button C.
► The display 1 shows the desired temperature for a few seconds.
3. Select the humidity symbol 6 by pressing the mode button D. Then briefly
press the On/Off button A.
► The evaporator switches on.
4. Set the humidity to 55% with the plus button B and the minus button C.
► The display 1 shows the desired humidity for a few seconds.
5. Select the light symbol 8 by pressing the mode button D. Then briefly
press the On/Off button A.
► The light switches on.
► The display 1 shows the intensity.
6. Set the light intensity to 50% with the plus button B and the minus button C.
► The display 1 shows the set intensity.
7. Select the user program symbol 4 by pressing the mode button D.
► The user program symbol lights up.
8. Select number 2 with the plus button B and the minus button C. Press the
plus button B and the minus button C for about 3 seconds.
► The saving of the user program is confirmed with a short flashing of the
user program symbol 4.
► The settings are stored in user program 2.
WORLD OF WELLNESS
p. 63/70
EN