Sentiotec Pro D Serie Instructions D'installation Et D'utilisation page 107

Installation instructions, for professionals only
Activating/deactivating phase alignment
Phase alignment is activated or deactivated using the function selection switch 3.
● The function selection switch 3 is set to the ON position as standard.
Phase alignment is therefore activated.
● If you wish to deactivate phase alignment, place the function selection switch
3 in the OFF position.
Activating two-sensor operation
The two-sensor operation is activated or deactivated using the function se-
lection switch 5. In two-sensor mode, the sauna control unit is operated with
the heater sensor with an overheat cut-out (F1 sensor) and the bench sensor
(F2/FTS2 sensor).
● The function selection switch 5 is set to the OFF position as standard. Single-
sensor mode is therefore activated.
● If you wish to activate two-sensor mode, place the function selection switch
5 in the ON position.
Selecting sensor for room temperature regulation with additional output
(only Pro D2i/Pro D3i)
For room temperature regulation using additional output (see "Room tempera-
ture control with the additional output" on page 53) the sensor for the
regulation can be selected with the function selection switch 6.
● The function selection switch 6 is set to the OFF position as standard. The heat-
er sensor (F1 sensor) is used for the regulation.
● If you wish to use the bench sensor (F2/FTS2 sensor), activate two-sensor
operation (see: "Activating two-sensor operation" on page 37) and
place the function selection switch 6 in the ON position.
WORLD OF WELLNESS
p. 37/70
EN