Sentiotec Pro D Serie Instructions D'installation Et D'utilisation page 114

Installation instructions, for professionals only
Setting mode of the additional output (only Pro D2i/Pro D3i)
Two different modes are available for the additional output:
1. Intensity regulation
2. Room temperature regulation
Perform the following steps to switch between the two modes:
1. Open the technician menu (see Page 39).
2. Select "Ir" by pressing the mode button D.
3. Press the On/Off button A.
4. Select the desired setting using the plus button B and the minus button C.
● "oFF" means intensity regulation (standard; dimmable/switchable see:
Page 42)
● "on" means room temperature regulation (see: Page 52)
5. Confirm the selection by pressing the On/Off button A.
6. Make other settings or leave the technician menu by pressing the On/Off
button A for about 3 seconds.
7. Then switch the power unit off for about 10 seconds.
Querying the software version
To query the software version of your sauna control unit, carry out the follow-
ing steps:
1. Open the technician menu (see Page 39).
2. Select "SOC" or "SOP" by pressing the mode button D.
● "SOC" displays the control panel software version (e.g. 116)
● "SOC" displays the power unit software version (e.g. 202)
3. Make other settings or leave the technician menu by pressing the On/Off
button A for about 3 seconds.
Exiting the technician menu
1. The technician menu is closed by pressing the On/Off button for about
3 seconds.
2. Then switch the power unit off for about 10 seconds. (see "Switching off
the power supply unit" on page 60).
WORLD OF WELLNESS
p. 44/70