Commissioning Using Lenze Settings - Lenze E82ZAFBC001 Instructions De Montage

Commissioning using Lenze settings

)
Note!
The controller is only ready for operation if a HIGH signal is applied to
ƒ
X3/28 (controller enable via terminal).
– Please observe that the controller can be inhibited through various
sources. All sources act like a series connection of switches.
– If the drive does not start although the controller has been enabled via
X3/28, check whether the controller has been inhibited through a
different source. Another source could be the s key of the keypad.
EDK82ZAFBC−001 DE/EN/FR 7.2
Commissioning using Lenze settings
l
Commissioning 7
43