Changing The Thread Size; Tapping Threads - Rothenberger ROPOWER 50 R Mode D'emploi

5.6

Changing the thread size

Ensure that the thread-tapping head is on the tool carriage and that the thread jaws correspond to the thread
size.
Insert the selector pin into the selector block with the necessary thread size.
The size is shown on the respective selector block.
Push T handle towards "D" to set dies.
5.7

Tapping threads

To protect your hands, the thread-tapping machine is fitted with a safety pedal!
The safety pedal has an Emergency Stop switch function!
If there is a dangerous situation, press the safety pedal right down. This stops the machine.
To restart the machine, press the release button on the side of the safety pedal.
Be careful that you do not crush your hands when lowering the thread-tapping head!
41