Reaming The Workpieces - Rothenberger ROPOWER 50 R Mode D'emploi

Move the pipe cutter (1) up so that it is not in the way. Turn the feeder hand wheel (6) anti-clockwise in order
to bring the pipe cutter into the position necessary for cutting the workpiece.
Move the pipe cutter down onto the workpiece and then press the ON switch or press the pedal.
Turn the handle of the pipe cutter powerfully clockwise and start to cut the workpiece.
Swivel the pipe cutter down and back again.
Do not collect the cut pipes in the trough! Take them out of the trough immediately after the cutting process
ends!
5.3

Reaming the workpieces

The cutting tip of the internal deburrer (1) is very sharp! Do not touch it with bare hands!
Risk of cutting and injury!
Ream the complete inner surface of the pipe cut with the pipe cutter (1).
Pull the internal deburrer (3) towards you and insert a pipe if there is not already one in the machine before
separation.
38
Turn rotary
handle into
cutting position
Lower pipe cutter onto the
pipe
Turn handle
and start
cutting