Operation Tips; When The Air Conditioner Is Not Going; Helpful Information - LG ATNQ50GMLA4 Manuel Du Propriétaire

MAINTENANCE AND SERVICE
28

Operation Tips!

Do not overcool the room.
This is not good for the health
and wastes electricity.
Make sure that the doors
and windows are shut tight.
Avoid opening doors and
windows as much as possible
to keep the cool air in the
room.
When the air conditioner is not
going....
When air conditioner is not going to
be used for a long time.
-
Operate the air conditioner at the following
settings for 2 to 3 hours.
Type of operation: Fan operation mode.
(Refer to page "Fan Mode".)
This will dry out the internal mechanisms.
-
Turn off the breaker.
CAUTION
!
Turn off the breaker when the air
conditioner is not going to be used for a
long time.
Dirt may collect and may cause a fire.
-
Remove the batteries from the Remote
Controller.
Keep blinds or curtains closed.
Do not let direct sunshine
enter the room when the air
conditioner is in operation.
Clean the air filter regularly.
Blockages in the air filter
reduce the airflow and lower
cooling and dehumidifying
effects. Clean at least once
every two weeks.

Helpful information

The air filters and your electiric bill.
If the air filters become clogged with dust, the
cooling capacity will drop, and 6 % of the
electricity used to operate the air conditioner
will be wasted.
When the air conditioner is to be
used again.
-
Clean the air filter and install it in the indoor
unit. (Refer to page "MAINTENANCE AND
SERVICE".)
-
Check that the air inlet and outlet of the
indoor/outdoor unit are not blocked.
-
Check that the ground wire is connected
correctly. It may be connect to the indoor
unit side.
Keep the room temperature
uniform.
Adjust the vertical and
horizontal airflow direction to
ensure a uniform temperature
in the room.
Ventilate the room
occasionally.
Since windows are kept
closed, it is a good idea to
open them and ventilate the
room now and then.