Risk From Moving Parts; Hot Surfaces - DeWalt D55250 Guide D'utilisation

area. An additional length of hose may be required.
Store flammable materials in a secure location away
from compressor.
Restricting any of the compressor ventilation
openings will cause serious overheating and could
cause fire. Never place objects against or on top of
compressor. Operate the compressor in an open area at least 3 feet
away from any wall or obstruction that would restrict the flow of fresh
air to the ventilation openings.
RISK FROM FLYING OBJECTS
The compressed air stream can cause soft tissue damage to exposed
skin and can propel dirt, chips, loose particles and small objects at
high speed, resulting in serious injury. Always wear ANSI Z28.1
approved safety glasses with side shields when using the compressor.
Never direct air stream at people or animals. Use only OSHA
approved air blow guns.
RISK TO BREATHING
The compressed air from your compressor is not safe
for breathing! The air stream may contain carbon
monoxide, toxic vapors or solid particles. Never inhale
air from the compressor either directly or from a
breathing device connected to the compressor.
Sprayed materials such as paint, paint solvents, paint
remover, insecticides, weed killers, etc. contain harmful vapors and
poisons. NOTE: Operate the compressor only in a well ventilated
area. Read and follow the safety instructions provided on the label or
safety data sheets for the material you are spraying. Use a
NIOSH/MSHA approved respirator designed for use with specific
application.

RISK FROM MOVING PARTS

The compressor is designed to run continuously. Always turn off the
compressor, and bleed pressure from the air hose and tank, before
performing maintenance or attaching tools and accessories.

HOT SURFACES

COMPRESSOR
PUMP HEAD
COMPRESSOR
CYLINDER
Keep your hair, clothing, and gloves away from
moving parts. Loose clothes, jewelry, or long hair can
be caught in moving parts. Air vents may cover
moving parts and should be avoided as well. Do not
remove the protective covers from this product.
Never operate compressor with guards or protective
covers that are damaged or removed. Never stand on
the compressor.
HOT SURFACES
Touching exposed metal such as the compressor head or outlet tube
can result in serious burns. Never touch any exposed metal parts on
the compressor during or immediately after operation. Compressor
will remain hot for several minutes after operation. Do not move the
compressor while it is running. Hot motor parts could cause burns
contributing to the dropping of the compressor, damaging the
compressor and/or injuring the operator.
ENGINE
Your air compressor is powered by a Honda
accidents with engines can be prevented if you follow all instructions
2
in this manual, the engine owner's manual and on the engine. Some
TRANSFER TUBE
(NOT SHOWN)
MUFFLER
ENGINE
CYLINDER
gasoline engine. Most
®