Sentiotec PRO-C3 Instructions Pour L'installation Et L'utilisation page 39

Instructions for use for the user
2. Press the bottom knob for one second.
► The mode you just selected is shown in the top display:
● Display: "StEP" – the additional output is in intensity regulation
mode.
● Display: "tE" – the additional output is in room temperature regula-
tion mode.
Intensity regulation when the dimmer switch function is activated
When the dimmer switch function for the additional output is activated, the power
for the additional device can be set to a scale of 0 to 7. At 0, the additional device
is switched off. 7 corresponds to full power.
1. Turn the function selector 2 to position C (additional output).
► The additional output symbol lights up.
2. Use the intensity selector 3 to set the preferred power of the additional
device.
3. Press the intensity selector 3.
► The additional device switches on.
► The intensity selector 3 lights up.
Intensity regulation when the dimmer switch function is deactivated
When the dimmer switch function for the additional output has been deactivated,
you can only switch the additional device on and off. The device will always
operate at full power.
1. Turn the function selector 2 to position C (additional output).
► The additional output symbol lights up.
► In the intensity display, "OFF" appears.
2. Press the intensity selector 3.
► The additional device switches on.
► The intensity selector 3 lights up.
► In the intensity display, "ON" appears.
p. 39/54
EN