SciCan SANAO 200 L Mode D'emploi page 16

2 Technical data
Tools
Air cooling
Spray air
Spray water
Page 16
SANAO 40 ST
Handpiece drill/contra-angle drill
made of steel or carbide
according to ISO 1797-1, type 2
- Shaft diameter: 2.334 – 2.350 mm
- With drill stop:
Shaft clamping length min. 12 mm / max. 22 mm
- Without drill stop:
Shaft clamping length min. 30 mm / max. 44.5 mm
8 Nl/min 2.5 bar (36.3 psi)
1.8 Nl/min 2.7 bar (39.2 psi)
50 ml/min 2 bar (29 psi)
SANAO PSI / PSO
Rubber cups/polishing brushes
- SANAO PSI:
With screw-in function
as per DIN EN ISO 13295
- SANAO PSO:
With a snap-on latch
as per DIN EN ISO 13295, latch type 5
Not applicable
Not applicable
Not applicable
SANAO EN