Lenz Digital plus LE1035A Manuel page 34

34
Bit Settings 2
50
1 (0) Not used
2 (1) 0
1
3 (2) 1
4 (3) 0
1
5–8 (4-7) Not used
51 Bit Settings of function outputs A and B
1 (0) 0
1
2 (1) Dimming of function output A only effective if Bit 3 is set
0
1
1
3 (2)
1
4 (3) 1
5–8 (4-7) Not used
0 – 255 Dimming value for function outputs A and B:
52
0 is off, 255 is maximum brightness.
53 1-255 control parameter for EMF
1 - 255 Mapping the function output C:
54
Bits 1 to 8 correspond to functions F1 to F8.
55 0 - 255 Mapping the function output D:
Speed-dependent braking delay
Speed-independent braking delay
Braking with DC if CV 29 Bit 3 = 0
EMF switch inactive
EMF switch active
Function outputs A and B act direction-dependently
Function output A reacts to F0, function output B reacts to F1
Function output A is always dimmed if Bit 3 is set
and Bit 1=0: Dimming with F1 on/off
and Bit 1=1: Dimming with F4 on/off
Function output A is can be dimmed
Function output B is can be dimmed
Information LE1035
1
0
0
0
0
0
0
0
0
64
8
F1, Bit 1
set
F2, Bit 2