Lenz Digital plus LE1035A Manuel page 26

26
5 Testing the installation
Place the locomotive on the programming track (without its housing) and read the address. Ex-
works, the decoder is programmed to the address 03. If you have connected the decoder correctly
thus far you should now be able to read the address. If you are not able to do so it is possible that
you have made a mistake when connecting the cables. Do not subject the loco to full running track
power until you obtain the correct "03" address read-out. Check the cable connections and change
them as required. You should now be able to send your locomotive on its first test run on your
layout.
6 Information on the features of LE1035
The features of LE1035 are stored in the so-called Configuration Variables, CVs. These CVs can be
altered anytime; the settings are stored permanently (even if the locomotive is not live).
Please consult the operating manuals for your digital system for information on how to change the
values of the CVs.
6.1 Disabling of delay
Use function 4 (ex-works setting, can be altered in CV60) to disable the starting and braking delay
as well as the constant braking distance during operation. The delays are disabled as long as the
function is active.
6.2 Shunting speed
The shunting speed halves the speed. This facilitates particularly sensitive control of the shunting
process. Use function 3 (ex-works setting, can be altered in CV59) to enable and disable the
shunting speed. If the shunting speed is enabled, the constant braking distance is disabled. The
shunting speed is enabled as long as the function is active.
Information LE1035