Inserting The Cd; Ejecting The Cd - TechniSat DIGITRADIO 20 CD Mode D'emploi

When burning a CD-R and CD-RW with audio data, various problems can arise which
could occasionally compromise smooth playback. This is caused by faulty software
and hardware settings or a blank disc being used. Should such errors arise, you
should contact your CD burner/burner software manufacturer's customer service or
search for the relevant information, e.g. on the Internet.
If you create audio CDs, observe the legal requirements and do not breach
third-party copyrights.
The device can play CDs with MP3 or WMA data and normal audio CDs (CD-
DA).
Due to the range of different encoder software, it cannot be guaranteed that
every MP3 file can be played without problems.
In the event of tracks/files being faulty, playback will continue with the next
track/file.
When burning the CD, it is worth doing so at low speed, creating the CD as a
single session and finalising it.

11.1 Inserting the CD

Insert the CD with the labelled side facing upwards until it is automatically pulled in
by the device.
After inserting a CD the device automatically changes to CD mode and the first
track on the CD is played.
Only insert CDs in the 12 cm standard format. Otherwise the CD drive could be
damaged.
To insert/remove the CD, please hold it by the edge.

11.1.1 Ejecting the CD

> In CD mode, press the Favourites memory 6 / CD Eject button to eject the
CD.
26
Labelled side