EINHELL FREELEXO BT Instructions D'origine page 48

Masquer les pouces Voir aussi pour FREELEXO BT:
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 52
Troubleshooting
Fault
The robot lawn mo-
wer is very loud.
The robot lawn
mower stays in the
charging station.
The robot lawn mo-
wer keeps returning
to the charging
station
The robot lawn mo-
wer comes to a halt
on the perimeter
wire and is unable
to get back to the
charging station.
IMPORTANT! Severed perimeter wires and consequential damages are not covered by the war-
ranty!
Anl_FREELEXO_BT_SPK13.indb 48
GB
Possible cause
- Damaged blades (10)
- A large amount of foreign
bodies adhere to the blades
(10)
- The robot lawn mower has
started too close to obstac-
les
- Damaged blade drive or
drive motor
- Other parts of the robot lawn
mower are damaged
- Incorrect work time settings
- The rechargeable battery is
empty
- The rain sensor has been
triggered
- The battery temperature is
high
- The battery is empty
- The length of the perimeter
wire (18) and therefore the
distance to the charging sta-
tion (19) is too great for the
battery being used.
- 48 -
Remedy
- Replace the blades (10). The 3 blades
(10) must all be replaced together at the
same time.
- The operating effi ciency of the robot lawn
mower is dependent on the sharpness of
the blades (10). You should therefore en-
sure that the blades (10) are maintained in
good condition.
- Switch off the robot lawn mower safely
and wear work gloves while you clean the
blades (10) in order to avoid getting cut.
- Arrange for the motor to be repaired or
replaced by your customer service center.
- Check the work time settings.
- The robot lawn mower will begin and end
its work in accordance with the set time
window. Outside this time window the
robot lawn mower stays in the charging
station (19).
- Remove all possible obstacles from the
perimeter wire (18). When you layout out
the perimeter wire (18), be sure to keep it
far enough away from any obstacles.
- Please use a battery with higher capacity.
- Important: When using a Multi-Ah battery
(e.g. 4-6 Ah), set the higher capacity.
Thanks to the gentle charging and di-
scharging of the robot lawn mower there is
no need to use the lower capacity in order
to extend the working life.
24.03.2022 09:56:32

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

34.139.41

Table des Matières