Installing The Duct - Stadler Form Sam Mode D'emploi

or
Sliding
panel
Sill
3. Cut the gasket (on an adhesive base) to fit the window and stick it to the
top edge of the panel.
or
Sliding
panel
Sill
4. Close the window tightly.
5. 5. Cut the gasket to fit the window and place it in the gap of the frame
between the inner and outer panes in the top of the frame.
Gasket
Installing the panel in a window with horizontal sliding frames
1. Cut the gasket (on an adhesive base) to fit the window and stick it to the
window frame.
2. Place the sliding panel for installing the duct in the window against the
window frame and adjust the length of the panel to the window height.
Open the frame and install the panel.
Sliding panel
or
All manuals and user guides at all-guides.com
Sliding
panel
Sill
Sliding
panel
Sill
Gasket A
(On an adhesive base)
Sliding panel
22.1"~38.6"
3. Cut the gasket (on an adhesive base) to fit the height of the window and
stick it to the side edge of the panel.
4. Close the window tightly.
5. Cut the gasket to fit the height of the window and place it in the gap of
the frame between the inner and outer panes in the side of the frame.
Dichtung

Installing the duct

The duct must be used only in the following modes of operation:
Cooling mode, heating mode (type: heat pump),
automatic mode
Fan mode, dry mode, heating mode
(type: electric heater)
1. Attach adapter B to the end of the duct.
2. Insert the other end of the duct in the air outlet opening of the air condi-
tioner so that it goes into the opening, then rotate it in the direction of
the arrow to secure it. Make sure the duct is securely fastened.
You can also install the duct in a wall
(not applicable to models that do not come with wall outlet adapter A,
screws and anchors).
or
The duct is used
The duct is not used
or