Remote Control - Stadler Form Sam Mode D'emploi

• To cancel the on/off timer, set the timer value to 0.0.
• If the air conditioner malfunctions (error code E1 or E2), the timer will be
disabled automatically.
ADDITIONAL INFORMATION ABOUT THE AIR CONDITIONER
In the event of a power failure
If a power failure occurs while the air conditioner is operating, it will auto-
matically resume operation in the current mode when power is restored.
Wait 3 minutes before turning it on again
After turning the air conditioner off, wait 3 minutes before turning it on
again. This is a safety precaution. After a power failure, the air conditioner
will automatically resume operation 3 minutes after power is restored.
Adjusting the air flow
• The swinging of the louvers is regulated automatically.
• To activate the louver swinging function, press the SWING button on the
control panel or remote control.
• To lock the louvers in position, press the SWING button again.
• Do not try to change the position of the louvers manually.

REMOTE CONTROL

Location of the remote control
To operate the air conditioner, point the remote control at the sensor on
the air conditioner. The range of the remote control is 8 meters. The device
beeps when you press a button on the remote control.
ATTENTION!
There should be no obstacles between the remote control and the sensor;
otherwise the air conditioner will not respond to commands from the remote
control.
Keep the sensor out of direct sunlight; otherwise the air conditioner may
not work correctly.
Ambient electronic devices may react to the remote control signal. If this
happens, remove such devices from the room. If this doesn't solve the prob­
lem, contact the service center.
Replacing the battery
The remote control is powered by two batteries (type R03/LR03) located in
the battery compartment in the rear.
1. Slide and remove the cover of the battery compartment.
2. Remove the old batteries and insert new ones, observing polarity.
3. Close the battery compartment.
NOTE
After replacing the batteries, you must re-enter the settings.
All manuals and user guides at all-guides.com
NOTE
Do not mix old and new batteries or battery types.
Do not leave batteries in the compartment for long periods of time (more
than 2 months).
Dispose of used batteries in accordance with existing regulations.
Description of the remote control
• On/off buttons for the following modes: Auto, Cooling, Drying, Heating,
Fan
• Timer set (up to 24 hours)
• Temperature range: 17°C~30°C
• Liquid crystal display.
Description of the remote control buttons
1. – button (TEMP DOWN) [Reduces the temperature]
Press this button to reduce the set temperature in the room at intervals of
1°C. The minimum temperature is 17°C.
2. + button (TEMP UP) [Increases the temperature]
Press this button to increase the set temperature in the room at intervals of
1°C. The maximum temperature is 30°C.
3. MODE button
Use this button to select the operating mode. Press the button repeatedly
to cycle through the choices:
AUTO COOL
AUTO — Automatic
DRY — Dry mode
FAN — Fan mode
4. SWING button [Louver swinging on/off]
Use this button to turn automatic swinging of the louvers on or off, or lock
them into position.
5. RESET button
Press this button to reset the remote control.
6. ON/OFF button
Use this button to turn the air conditioner on or off.
7. FAN button
Use this button to select the fan speed. Press it repeatedly to cycle through
the choices:
AUTO HIGH
AUTO — Automatic
MED — Medium fan speed
DRY HEAT FAN
COOL — Cooling
HEAT — Heat mode
MED LOW
HIGH — High fan speed
LOW — Low fan speed