Stadler Form Sam Mode D'emploi page 25

3. Knife or scissors
4. Hand saw (if you need to reduce the size of the panel for installing the
duct in the window because the window is too narrow).
• The air conditioner must be placed on a flat, sturdy surface to minimize
noise and vibration. Make sure the surface on which you place the air
conditioner is sturdy enough to support it.
• For easy portability, the air conditioner is equipped with roller wheels, but
you can only roll the unit on a smooth, level surface. Avoid rolling the air
conditioner on soft floor coverings such as carpets, etc. Never roll it on a
surface or over anything that could damage it.
• When installing the air conditioner, make sure to allow free access to the
properly grounded electrical outlet. Install the air conditioner so that the
air inlet and outlet openings are not blocked by any obstacles.
• For best results, the distance between the air conditioner and the wall
should be 30-100 cm.
A:30cm-100cm B:
The sliding panel for installing the duct in the window is designed for stand-
ard window sizes. For non-standard window sizes, change the installation
procedure accordingly. Show how to install the panel in a standard window
and the sliding panel.
Vertical window
Length of the sliding panel:
Min: 56.2 cm
Max: 98.2 cm
Vertical window
Length of the sliding panel:
Min: 56.2 cm
Max: 98.2 cm
All manuals and user guides at all-guides.com
or
30cm
or
Horizontal
window
Length of the sliding panel:
Min: 56.2 cm
Max: 98.2 cm
Horizontal
window
Length of the sliding panel:
Min: 56.2 cm
Max: 98.2 cm
Latch
Sliding panel
NOTE
If the window opening is less than the specified size, the panel must be
shortened to the appropriate length on the other side of the opening for the
duct. Do not cut an opening for the duct in the panel manually!
Installing the panel in a window with vertically sliding frames
1. Cut the gasket (on an adhesive base) to fit the window and stick it to the
window sill.
2. Place the sliding panel for installing the duct in the window against the
window sill and adjust the length of the panel to fit the width of the
window. Open the frame and set the panel on the window sill.
or
or
Latch
Sliding panel
Gasket A
(On an adhesive base)