Repair Jobs On The Systems; Spare Parts; Storage; Inspections - zarges Z600 Notice De Montage Et D'utilisation

7.2

Repair jobs on the systems

Only trained technicians should be allowed to perform
repair jobs on the systems.
If repair jobs are performed on load bearing compo-
nents, such as welding jobs, these must be tested by an
expert.
Only geniune parts of the manufacturer should be used
in repair jobs.
The use of other spare parts and accessories is not al-
lowed and should be undertaken in exceptional cases
only after obtaining the written approval of ZARGES.
After the repair job, the system should be operated only
after confirming that it is functioning smoothly. In this
context, the repaired areas and the safety devices must
be subjected to a special expert opinion.
7.3

Spare parts

Geniune spare parts can be ordered from ZARGES Gm-
bH.
8

STORAGE

The system should be stored in such a way that any dam-
age is ruled out. The system must be stored in such a way
that it is protected against atmospheric influences.
9

INSPECTIONS

• Before each use, the systems must be checked to en-
sure that they are functioning properly and are in
proper condition The systems should not be used if
defects are detected. The systems can be used only
after the faults have been remedied.
All components are to be checked for deformities,
crushing, crack formations.
Check that nuts and screws are tight.
In case of systems with hooks / snap-in brackets, the
customer provided support for the hooks/snap-in
brackets must also be checked. The supports are to
be checked for wear and tear.
• The systems should be subjected to regular checks
by an expert to ensure their proper condition.
Regularly means that a check is performed after an
appropriate period depending on operating condi-
tions. A daily check can be necessary in case of per-
manent heavy-duty use of the system.
9.1

Inspection stickers

Inspection stickers can be ordered from ZARGES under
Order No. 207396.
The inspection sticker is to be affixed on the system after
a install is performed with positive results.
The inspection stickers are to be affixed in such a way
that the month and year of the next install (maximum one
year after the last inspection date) are clearly visible to
the user.
GB
- 28 -
o
N 291311