Function; Adjusting The Flow Time; Adjusting The Range; Hygiene Flush - Franke AQUACONTACT AQCT0029 Notice De Montage Et De Mise En Service

12. Function

☞
You can switch between time control and body reflection using the remote control
(not in the scope of delivery; see Accessories,
Time control
Triggering the flow of water
12.1 Hold your hand near the sensor.
• The water will flow.
• The water stops automatically following the set flow time or if you place your hand
near the sensor again.
☞
The flow duration is factory-set to 30 seconds.
Body reflection
Triggering the flow of water
12.2 Hold your hand near the sensor.
• The water will flow.
• The water stops automatically once you leave the range of the sensor or after
5 minutes, at the latest.

13. Adjusting the flow time

You can adjust the flow time in increments of 10 seconds from 10 to 60 seconds
using the remote control (not part of the scope of delivery; see Accessories,
chapter 24).

14. Adjusting the range

You can adjust the range for body reflection using the remote control (not part of the
scope of delivery; see Accessories,

15. Hygiene flush

☞
At the factory, the hygiene flush function is set so that water flows for 10 seconds
after 24 hours.
You can adjust the hygiene flush parameters using the remote control (not part of the
scope of delivery; see Accessories,
You can choose an interval of 0, 8, 24, 48, or 72 hours for the hygiene flush function
(0 = hygiene flush deactivated). You can adjust the flow time in 10 second
increments from 10 to 60 seconds.
8
chapter
chapter 24).
chapter 24).
24)