Communication; Pc Software Installation - Endress+Hauser Memograph M RSG40 Mode D'emploi

• If you are commissioning a unit that is already configured, measuring is immediately started in
accordance with the settings. The values of the display group currently configured appear on the
display.
• When you first commission the unit, program the set up in accordance with the description in the
Operating Instructions on CD-ROM, chapter 6.3.
5.4

Communication; PC software installation

!
Note!
Version V1.25.0.0 (or higher) of the PC software supplied must be installed to be able to establish
communication between the unit and the PC. To be on the safe side, you should install the current
PC software package (CD–ROM supplied).
5.4.1 Installing the PC software supplied
!
Note!
The "Arial Unicode MS™" font must be installed on your PC to operate the PC software supplied.
Otherwise certain characters might be displayed incorrectly or not at all. Check this on your PC
under "Control Panel - Fonts". If this font is not installed, please refer to your Microsoft-Office
Microsoft-Windows
!
Note!
You need administrator rights to install the software.
1. Install the supplied PC software on your computer. The program's Operating Instructions can
be printed out after installation, if required.
2. Once the PC software has been installed successfully, you can launch the software under "Start
-> All programs".
5.4.2 Communication via USB / USB driver installation
Once the PC software supplied has been installed successfully, the unit can be connected to the PC
with a USB cable. The operating system automatically recognizes the new USB unit.
!
Note!
Proceed as follows to then install the USB driver (depends on operating system):
1. The Windows prompt "Should a connection be established with Windows Update to look for
software?" appears. Click "No, not this time" and then "Next".
2. The "What do you want the wizard to do?" window appears. Select "Install the software
automatically (Recommended)" and then click "Next".
You can now start the PC software supplied to establish communication with the unit.
"
Caution!
Wait at least 15 seconds before plugging in and out the USB connection from the PC to the unit!
®
manual.
Commissioning and operation
®
or
33